F2-S19机油冷却器安装教程

Please refer to the following process:
Step 1:Remove the fan screws      
Step 2:Remove the screws on the panel
      Step 3:Remove 8 screws of the fan 
Step 4:Remove the power supply and junction box screws
Step 5:Open panel box 
Step 6:Unplug the fan
Step 7:Install the fan simulator       
Step 8:Fix the fan simulator
Step 9:Open the power housing
Step 10:Locate the fan connector for the power supply
Step 11:Unplug the power fan
Step 12:Install the power housing
Step 13:The power supply fan only needs to be disconnected from the power supply and does not need to be disassembled. It can be retained on the power box
Step 14:Disassemble the baffle of the force calculation plate
Step 15:Remove the baffle of the force calculation plate on the other side
Step 16:Remove the interface between the force calculation board and the power supply. (Only second-hand mining machines need to pull out the force calculating board to clear the dust, and new mining machines do not need to pull out the force calculating board, skip steps 17 to 22)
Step 17:Disassemble the data line interface of the force calculation board
Step 18:Unplug the data cable of the force calculation board and remove the dust
Step 19:Pull out the force calculation board in turn, and install it back to the original position after dust removal
Step 20:Remove the dust in turn and then replace it
Step 21:Replace the baffle of the force calculating plate. (The baffle must be installed back to fix the function of the force calculating plate)
Step 22:Replace the force calculation plate baffle on the other side
Step 23:Install the hand grip. (The lifting handle must be installed. It is difficult to take out the miner when it is soaked in oil, so it is necessary to take out the miner.)
Step 24:Replace the power supply anti contact housing. (It must be replaced to avoid electric shock when it is taken out for use.)
Step 25:The modification of oil cooling is completed.
Step 26:Open a single oil cooled ore box
Step 27:Put the mining machine into the oil cooled ore box
Step 28:Plug in the power cord and network cable after putting them into the mining machine
Step 29:Pumping oil to ore box
Step 30:Wait for 1 minute after refueling
Step 31:Pump startup and operation inspection of oil circuit
Step 32:When the oil fills the pipeline for the first time, it is necessary to increase the oil, so that all mining machines are immersed in the oil
Step 33:Start the machine after confirming that all the oil is in place

So far, the tutorial is over. Thank you for watching